The channel cover plate mold is divided into plastic cover plate mold and cover plate steel mold. In some side ditches of driving roads, it is difficult to see the plastic cover plate mold to prefabricate the cement channel cover plate laying, the channel cover plate mold, the drainage channel cover plate mold, the channel cover plate mold because the cement material itself has low bearing capacity and is prone to safety accidents. Therefore, the channel cover plate of steel grid plate or galvanized plate is mostly laid 。 So where should the channel cover mould be used? Generally, it is recommended to lay the cover mould of the channel only in the areas where the flow of people and vehicles is not large, such as ditches, channels, sewers, etc. it is also applicable to strengthen the process of prefabricated cement ditch cover, and has higher cost performance. Relying on the new social development trend, the channel cover plate mold will develop to the special, precise, excellent and strong direction on the original basis, and new technologies are emerging constantly, which promotes the further upgrading of the cover plate mold. The competitiveness of the drain cover mould market needs more competitiveness among products. The new social pattern will inevitably drive the new market pattern depending on the quality of products.
The channel cover mold is designed by increasing the use of stiffeners and injection materials, and from the perspective of customers. During the embedding process of the cobblestone cement products after the later pouring and forming, they can be buried deeper, and have certain resistance to the impact of water flow, which has an effective slope protection effect. The design of small chamfers on both sides of the mold makes the cobblestone after the pouring and forming have a certain beautification in appearance. In order to better protect the mold from deformation during the pouring process, the reinforcement is used in the mold design.